Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0685, P0686, P0687
Control Circuit = Commanded state does not match the actual state - Greater than 2 s
P0689, P16AF
Engine Controls Ignition Relay Feedback Signal = Commanded state does not match the actual state - Greater than 6 s
P0690, P16B3
Engine Controls Ignition Relay Feedback Signal = Commanded state does not match the actual state - Greater than 6 s
P1682, P16A7
The following parameters are not within 3 V of each other :
- Ignition 1 Signal
- Engine Controls Ignition Relay Feedback Signal
- Engine Controls Ignition Relay Feedback 2 Signal