Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify there are no DTCs set related to the following component/system :
- B9 Ambient Air Temperature Sensor
- B14A Transmission Output Shaft Speed Sensor
- B26 Crankshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B115 Vehicle Speed Sensor
- Exhaust Aftertreatment System
- Fuel System
- Induction System
- If a related DTC is set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If a related DTC is not set
- Verify the condition does not exist :
- Aftermarket equipment/accessories : Performance Components - Installed
- Accessory drive belt component - Worn / Failed
- Fuel - Contamination Refer to : Contaminants-in-Fuel Diagnosis
- If a condition exists
Repair or replace as necessary
- Go to next step : If no condition exists
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC does not set
- If the DTC sets
- All OK.