Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On / Vehicle - In Service Mode
Verify DTC P0697, P06A3 is not set.
- If any of the DTCs are set
  Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If none of the DTCs are set
Verify the scan tool parameter :
- APP Sensor 1 Circuit Status = OK
- APP Sensor 2 Circuit Status = OK
- If not the specified state
  Refer to : Circuit/System Testing
- Go to next step : If the specified state
Verify the scan tool parameter :
- APP Sensor 1 = 0.8 to 4.5 V - The value should not spike or drop out while moving the sensor through the entire range.
- APP Sensor 2 = 0.4 to 2.5 V - The value should not spike or drop out while moving the sensor through the entire range.
- If not in the specified range or does not change
  Refer to : Circuit/System Testing
- Go to next step : If in the specified range and changes
Verify the scan tool parameter : APP Sensor 1 and 2 = Agree
- If not the specified state
  Refer to : Circuit/System Testing
- Go to next step : If the specified state
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to : Circuit/System Testing
- Go to next step : If the DTC does not set
All OK.