Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

NOTE:

Cold Start-Up = Required

Engine - Idling
Verify the scan tool parameter : Cylinder 1 - 6 Current Misfire Counter = Less than 1
- If 1 or greater
1. Ignition - On / Vehicle - In Service Mode & Engine - Off
2. Verify the following conditions do not exist :
  - Fuel Pressure - Low / High - Refer to : Fuel System Diagnosis .
  - Fuel - Contaminated / Poor Quality - Refer to : Alcohol/Contaminants-in-Fuel Diagnosis
  - If a condition exists - Repair or replace as necessary
  - If no condition exists - Replace the component : Q17 Fuel Injector
- Go to next step : If less than 1
All OK.