LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Controls And Fuel - 4.3L (LV1) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P0496 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On / Vehicle - In Service Mode
  2. Perform the scan tool control function : EVAP Purge/Seal - Not Venting
  3. Engine - Idling
  4. Verify the scan tool parameter : Fuel Tank Pressure Sensor = Less than 1.7 V - For 90 s
    • If 1.7 V or greater 

      Replace the component : Q12 Evaporative Emission Purge Solenoid Valve

    • Go to next step : If less than 1.7 V 
  5. All OK.