Conditions for Running the DTC

DTC P0442

• DTC P0106, P0107, P0108, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0125, P012B, P012C, P012D, P0128, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P0502, P0503, P0722, P0723, P2227, P2228, P2229, P2610 = Not set
• Ambient Air Temperature = Between : 0 to 34°C (32 to 93°F)
• Barometric Pressure = Greater than 70 kPa (10.15 PSI)
• ECT Sensor = Greater than 63°C (145°F)
• Engine Run Time = Greater than 10 min - Before ignition off
• Fuel level = 10 to 90%
• Ignition/Vehicle - Off
• Start-Up ECT & Start-Up IAT = Within 8°C (14°F) of each other
• Time since diagnostic ran last = 17 h - Test Passedor10 h - Test Failed
• Vehicle Distance Traveled During Drive Cycle = Greater than 8 km (5 mi) - Before ignition off

Frequency the DTC runs = Once - Per hot soak - DTC test could take 40 min to complete

DTC P0455

• DTC P0068, P00C8, P00C9, P00CA, P0090-P0092, P0106-P0108, P0111-P0114, P0116-P0118, P0122, P0123, P0125, P0128, P0191-P0193, P0222, P0223, P06A3, P06DB, P06DE, P0A1D, P160D, P160E, P1682, P16A0-P16A2, P16F3, P1104, P127A, P127C, P127D, P15F2, P0443, P0449, P0452, P0453, P0502, P0503, P0601, P0604, P0606, P0697, P2100-P2103, P2122, P2123, P2127, P2128, P2135, P2138, P215B, P2176, P228C, P228D, U0073, U0074, U0293, U1817 = Not set
• Barometric Pressure (kPa) = Greater than 70 kPa (10.15 PSI)
• Fuel level = 10 to 90%
• Ignition Voltage = Greater than 10 V
• EVAP Purge Solenoid Valve Command Greater than 1.50%
• Start-Up ECT & Start-Up IAT = Within 8°C (14°F) of each other
• Start-Up ECT = Less than 35°C (95°F)
• Start-Up IAT = Between : 4 to 34°C (39 to 93°F)

Frequency the DTC runs = Once Per cold start-up