Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
WARNING:
Refer to : Fuel and Evaporative Emission Pipe Warning .
CAUTION:
Refer to : Clean, Dry, Low Pressure Gas Source Caution .
- Verify the following conditions do not exist :
- Damaged, defective, or loose component :
- Fuel Tank Filler Cap or Capless Type Fuel Fill
- Evaporative Emission Canister Purge Solenoid Valve
- Evaporative Emission Pipe - Kinked or Disconnected
- EVAP Vent Solenoid Valve
- Evaporative Emission Canister
- If a condition exists - Repair or replace as necessary
- Go to next step : If no condition exists
- Damaged, defective, or loose component :
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set..
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC does not set
- If the DTC sets
- All OK.