Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0335Condition 1
- DTC P0101, P0102, P0103 = Not set
- Camshaft Position Sensor = Signal received
- MAF Sensor = Greater than 3 g/s
Condition 2
- Engine = Running
- Starter = Inactive
Condition 3
- DTC P0340, P0341 = Not set
- Engine = Running
Frequency the DTC runs = Continuously - After the running conditions are met
P0336Condition 1
- DTC P0335, P0651 = Not set
- MAF Sensor = Greater than 3 g/s
- Engine Speed = Greater than 450 RPM
Condition 2
- Engine = Running
- Starter = Inactive
Condition 3
- DTC P0101, P0102, P0103 = Not set
- Camshaft Position Sensor = Signal received
- MAF Sensor = Greater than 3 g/s
- Starter = Active
Condition 4
- DTC P0340, P0341 = Not set
- Engine = Running
Frequency the DTC runs = Continuously - After the running conditions are met