Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the electrical connector : G18 High Pressure Fuel Pump
- Test for 9 to 11 ohms between the test points : Control terminal 1 & Control terminal 2
- If not between 9 and 11 ohms
Replace the component : G18 High Pressure Fuel Pump
- Go to next step : If between 9 and 11 ohms
- If not between 9 and 11 ohms
- Test for infinite resistance between the test points : Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component : G18 High Pressure Fuel Pump
- Go to next step : If infinite resistance
- If less than infinite resistance
- All OK.
NOTE:
As little as 2 ohms of resistance in a circuit may cause a DTC to set.