Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
DTC P0010, P2088, P2089
- Ignition Voltage = Greater than 11 V
- Ignition Switch Position = Run/Crank
- Camshaft Position Actuator Solenoid Valve = On
Frequency the DTC runs = Continuously - After the running conditions are met
DTC P0011
- DTC P0010, P0016, P0335, P0336, P0340, P0341 = Not set
- Ignition Voltage = Greater than 11 V
- Engine = Running
- Desired Camshaft Position = Does not vary greater than 7.5° - For greater than 2 s
- Camshaft Position Actuator = Enabled
- Power Take-Off Switch = Off - If equipped
Frequency the DTC runs = Continuously - After the running conditions are met