Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Install a NEW throttle body gasket (1).
Position the throttle body (2).
- Install the throttle body bolts (1) and tighten to 10 N.m (89 lb in).
Connect the electrical connector (1).
- Air Cleaner Outlet Duct - Install - Air Cleaner Outlet Duct Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) , or Battery Negative Cable Disconnection and Connection (Dual Battery)
- Perform the throttle body idle air flow compensation reset. Throttle Body Idle Air Flow Compensation Reset
CAUTION:
Refer to Fastener Caution .