Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Engine Cover - Remove - Engine Cover Replacement
Perform the following steps to remove the spark plug wire (1) from the spark plug:
- Twist the spark plug wire boot 1/2 turn in each direction to loosen.
- Pull on the spark plug wire boot to remove the spark plug wire from the spark plug.
Perform the following steps to remove the spark plug wire (1) from the ignition coil:
- Twist the spark plug wire boot 1/2 turn in each direction to loosen.
- Pull on the spark plug wire boot to remove the spark plug wire from the ignition coil.