Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
WARNING:Wear safety glasses when using compressed air in order to prevent eye injury.
- Using compressed air, blow any debris from around the fittings.
Using CH-41769 fuel line quick disconnect tool, insert the correct size tool into the female connector, then push inward to release the locking tabs.
Pull the fuel line connection apart.
- Using a clean shop towel, wipe off the male pipe end.
- Inspect both ends of the fuel line connections for dirt and burrs. Clean or replace the components as required.
CAUTION:
If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.