Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Place a suitable adjustable jack under the fuel tank.
- Use a suitable strap to strap fuel tank to jack.
- Connect the fuel tank fuel pump module connector.
- Fuel Tank (1) - Install
Fuel Tank Strap (2) - Install [2x]
- Fuel Tank Strap Bolt (1) - Install and tighten [2x] 30 N.m (22 lb ft)
- Remove strap holding fuel tank to jack.
Fuel Feed Pipe (3) - Connect - Metal Collar Quick Connect Fitting Service
- Evaporative Emission Front Pipe (2) - Connect - Plastic Collar Quick Connect Fitting Service
- Electrical Connector (1) - Connect
Fuel Tank Filler Hose (3) - Install
- Fuel Tank Filler Hose Clamp (2) - Install and tighten4 N.m (35 lb in)
- Evaporative Emission Hose (1) - Connect - Plastic Collar Quick Connect Fitting Service
- Refill the fuel tank.
- Inspect for fuel leaks.
CAUTION:
Refer to Fastener Caution .