LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Controls And Fuel - 4.3L (LV1) - Repair Instructions) >> Repair Instructions >> Fuel Injection Fuel Rail Assembly Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4855990Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Whenever ANY fuel injector is removed from the cylinder head or the fuel injection fuel rail, the fuel injector MUST be rebuilt.
    • Some vehicles are NOT originally equipped with fuel injector dust seals. If NOT present when removing the fuel injectors, ensure NEW seals are installed regardless of whether present or not.

    Disassemble and inspect the following components for ALL exposed fuel injectors (1) :

    • Fuel Injector Hold Down Clamp (2) - ONLY replace if necessary
    • Fuel Injector Collar (3) - ONLY replace if necessary
    • Fuel Injection Fuel Rail Seal (4) - ALWAYS replace
    • Fuel Injector Seal Spacer (5) - ALWAYS replace
    • Fuel Injector Dust Seal (6) - ALWAYS replace
    • Fuel Injector Nozzle Housing Seals (7) - ALWAYS replace
  2. Rebuild ALL removed fuel injectors (1). Fuel Rail and Injectors Cleaning and Inspection
  3. GM4855991Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    All fuel injector components MUST be clean and free of debris prior to installation.

    Install the rebuilt fuel injectors (1). Fuel Injector Replacement 

  4. GM4855992Courtesy of GENERAL MOTORS COMPANY

    Connect the fuel injector wiring harness (1) to the bracket, the fuel pump, and the fuel injectors.

  5. Secure the fuel injector wiring harness with the straps (2).
  6. GM4855993Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure the fuel injection fuel rail bolts are retained securely in the fuel injection fuel rail insulators BEFORE applying the thread locking adhesive.

    Perform the following steps to install the fuel injection fuel rail bolts (1) :

    1. Thoroughly clean the residue from the bolt threads with denatured alcohol or equivalent and allow to dry.
    2. Install the bolts into the fuel injection fuel rail insulators.
    3. Apply a 0.5 mm (0.02 in) band of thread locking adhesive to the threads of each bolt. Adhesives, Fluids, Lubricants, and Sealers
  7. GM4855994Courtesy of GENERAL MOTORS COMPANY

    Position the fuel injection fuel rail (1) and start the fuel injection fuel rail bolts (2) by hand.

    8. CAUTION:

    Refer to Fastener Caution .

  8. Tighten the fuel injection fuel rail bolts (2) in even increments to 25 N.m (18 lb ft).
  9. GM4855928Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector (1).

  10. GM4856258Courtesy of GENERAL MOTORS COMPANY

    Install the NEW fuel feed intermediate pipe - position 1. Fuel Feed Intermediate Pipe Replacement - Position 1 

  11. Inspect for leaks using the following procedure:
    1. Turn ON the ignition with the engine OFF for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition with the engine OFF.
    4. Inspect for fuel leaks.
  12. GM4853010Courtesy of GENERAL MOTORS COMPANY

    Install the fuel pump insulator (1). Fuel Pump Insulator Replacement 

scientia non olet · About LEMON Manuals