Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Fuel Feed and Evaporative Emission Front Pipe (4) Install
- Install the oxygen sensor retainer to the pipe retainer.
- Fuel Feed Pipe (3) - Connect - Metal Collar Quick Connect Fitting Service
- Evaporative Emission Pipe (2) - Connect - Plastic Collar Quick Connect Fitting Service
- Fuel Feed and Evaporative Emission Front Pipe Nut (1) - Install and tighten25 N.m (18 lb ft)
Retainer (2) - Install [2x]
Retainer (2) - Install
- Fuel Feed and Evaporative Emission Front Pipe Bolt (1) - Install and tighten10 N.m (89 lb in)
- Connect the electrical connector.
Evaporative Emission Pipe (4) - Connect - Plastic Collar Quick Connect Fitting Service
- Fuel Feed Pipe (3) - Connect - Metal Collar Quick Connect Fitting Service
- Retainer (2) - Install
- Fuel Feed and Evaporative Emission Front Pipe Retainer Bolt (1) - Install and tighten8.5 N.m (75 lb in)
- Lower the vehicle.
- Engine Cover - Install - Engine Cover Replacement
CAUTION:
Refer to Fastener Caution .