Engine Coolant Temperature Sensor Replacement

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Drain the cooling system. Cooling System Draining and Filling (Static LC8, LV1, L96) , or Cooling System Draining and Filling (GE47716 LC8, LV1, L96) Disconnect the radiator inlet hose from the water pump and reposition. Radiator Inlet Hose Replacement (LV1) Disconnect the electrical connector.
1	Engine Coolant Temperature Sensor CAUTION: Refer to Component Fastener Tightening Caution . Tighten 20 N.m (15 lb ft)

Callout

Component Name

Preliminary Procedures

Engine Coolant Temperature Sensor

CAUTION:

Tighten
20 N.m (15 lb ft)