Crankshaft Position Sensor Replacement

WARNING: This page is about a different variant/trim than selected.

GM4852293

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Preliminary Procedures

Starter Replacement (LV1)
Disconnect the electrical connector.

1

Crankshaft Position Sensor Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
25 N.m (18 lb ft)

2

Crankshaft Position Sensor

Procedure

The seal is reusable, inspect the seal and replace if damaged.
A NEW sensor will come with a NEW seal.
Lubricate the seal with clean engine oil. Adhesives, Fluids, Lubricants, and Sealers
Perform the crankshaft position variation learn. Crankshaft Position Variation Learn