LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Controls And Fuel - 4.3L (LV1) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Magnet Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) , or Battery Negative Cable Disconnection and Connection (Dual Battery)
  2. Water Pump - Remove - Water Pump Replacement (LV1)
  3. GM4852301Courtesy of GENERAL MOTORS COMPANY

    Disconnect the electrical connector (1).

  4. Remove the camshaft position actuator magnet bolts (2).
  5. GM4852302Courtesy of GENERAL MOTORS COMPANY

    Remove the camshaft position actuator magnet (1).

  6. Remove and DISCARD the camshaft position actuator magnet gasket (2).