Low Pressure Diesel Hydrocarbon Injector Replacement

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Fuel Feed Hydrocarbon Injection Front Pipe @ Low Pressure Diesel Hydrocarbon Injector - Disconnect - Fuel Feed Hydrocarbon Injection Front Pipe Replacement Disconnect the electrical connector.
1	Low Pressure Diesel Hydrocarbon Injector Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Low Pressure Diesel Hydrocarbon Injector CAUTION: Refer to Component Fastener Tightening Caution . Tighten 45 N.m (33 lb ft)

Callout

Component Name

Preliminary Procedures

Fuel Feed Hydrocarbon Injection Front Pipe @ Low Pressure Diesel Hydrocarbon Injector - Disconnect - Fuel Feed Hydrocarbon Injection Front Pipe Replacement
Disconnect the electrical connector.

Low Pressure Diesel Hydrocarbon Injector Bolt [2x]

CAUTION:

Tighten
9 N.m (80 lb in)

Low Pressure Diesel Hydrocarbon Injector

CAUTION:

Tighten
45 N.m (33 lb ft)