With Scan Tool
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Select : Module Diagnostics
- Select : Engine Control Module
- Select : Configuration/Reset Functions
- Select : Fuel Injector Correction Reset
- Select : Cylinder 1 - 4 Fuel Injector Correction Value Reset or All Cylinders Fuel Injector Correction Value Reset
- Select : Reset
- Follow the instructions on the scan tool.
Verify the scan tool parameter : Cylinder 1 - 4 Fuel Injector Correction Value = 0 ms
- If not the specified state
Refer to : Step 1
- Go to next step : If the specified state
- If not the specified state
- All OK.