LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Repair Instructions) >> Repair Instructions >> Exhaust Gas Recirculation Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4629552Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install a NEW gasket.

    Exhaust Gas Recirculation Pipe Gasket (3) - Install

  2. NOTE:

    Install a NEW seal.

  3. Exhaust Gas Recirculation Pipe Seal (2) - Install
  4. Exhaust Gas Recirculation Pipe (1) - Install
  5. GM4629502Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Exhaust Gas Recirculation Pipe Bolt (2) - Install and tighten [2x] 10 N.m (89 lb in)

  6. Exhaust Gas Recirculation Pipe Bolt (1) - Install and tighten [2x] 25 N.m (18 lb ft)
  7. Engine Cover - Install - Engine Cover Replacement