LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Repair Instructions) >> Repair Instructions >> Exhaust Gas Recirculation Cooler Temperature Sensor Replacement - Position 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Engine Cover - Remove - Engine Cover Replacement
  2. GM4627753Courtesy of GENERAL MOTORS COMPANY

    Exhaust Gas Recirculation Cooler Temperature Sensor Electrical Connector (1) - Disconnect

  3. Exhaust Gas Recirculation Cooler Temperature Sensor Wiring Harness Retainer (2) - Disengage
  4. GM4627762Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Apply penetrating oil to the sensor and allow to soak for 10 minutes prior to removal.

    Exhaust Gas Recirculation Cooler Temperature Sensor (1) - Remove

scientia non olet · About LEMON Manuals