With Scan Tool
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Select : Module Diagnostics
- Select : Engine Control Module
- Select : Configuration/Reset Functions
- Select : Reset Functions
- Select : Exhaust Aftertreatment Fuel Injector Reset
- Follow the instructions on the scan tool. - The procedure will complete within 10 s
Verify the scan tool procedure was successful.
- If the procedure was not successful
- Verify the following conditions do not exist :
- Battery Voltage - Low
- DTC Present
- If a condition exists - Repair or replace as necessaryRepeat step 1
- If no condition exists - Repeat step 1
- Go to next step : If the procedure was successful
- All OK.