LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. GM4622853Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness (1) @ Electrical Connector (2) - Disconnect

  3. Electrical Connector (2) @ Crankshaft Position Sensor Bracket (3) - Unclip [2x]
  4. GM4622881Courtesy of GENERAL MOTORS COMPANY

    Crankshaft Position Sensor Bracket Bolt (1) - Remove [2x]

  5. Crankshaft Position Sensor Bracket (2) - Remove
  6. GM4622964Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Do not allow the crankshaft position sensor reluctor ring to come into contact with external magnetic fields or sharp metal objects. Do not drop the crankshaft position sensor reluctor ring. Do not damage the rubberized encoder track. Failure to follow these precautions may cause damage to the component.

    Crankshaft Position Sensor Bolt (1) - Remove

  7. Crankshaft Position Sensor (2) - Remove
scientia non olet · About LEMON Manuals