Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
Do not allow the crankshaft position sensor reluctor ring to come into contact with external magnetic fields or sharp metal objects. Do not drop the crankshaft position sensor reluctor ring. Do not damage the rubberized encoder track. Failure to follow these precautions may cause damage to the component.
Crankshaft Position Sensor (2) - Install
- Crankshaft Position Sensor Bolt (1) - Install and tighten 5 N.m (44 lb in)
Crankshaft Position Sensor Bracket (2) - Install
- Crankshaft Position Sensor Bracket Bolt (1) - Install and tighten [2x] 9 N.m (80 lb in)
Electrical Connector (2) @ Crankshaft Position Sensor Bracket (3) - Install [2x]
- Engine Wiring Harness (1) @ Electrical Connector (2) - Connect
- Remove the supports and lower the vehicle. Lifting and Jacking the Vehicle
- Perform the crankshaft position variation learn. Crankshaft Position Variation Learn
CAUTION:
Refer to Fastener Caution .