Camshaft Position Sensor Replacement
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Air Cleaner Assembly Replacement |
|
| 1 | Camshaft Position Sensor Fastener
CAUTION:
Refer to Fastener Caution . Tighten 11 N.m (97 lb in) |
| 2 | Camshaft Position Sensor Procedure Disconnect the electrical connector from the camshaft position sensor. |
| 3 | Camshaft Position Sensor Seal
NOTE:
If reinstalling the sensor, inspect the seal and replace as needed. Always install the NEW seal supplied with the sensor. |