Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P2ADA
- DTC P1015, P1016, P1017, P1018, P1019, P101A, P262B, P2ADB, P2ADC, P2ADD, or U010E is not set.
- The ignition is on.
- The ignition voltage is greater than 11 V.
- The ignition has been off for greater than 8 h.
The DTC runs for 8 s after engine is started when the above conditions are met.
P2ADB, P2ADC
- DTC P1015, P1016, P1017, P1018, P1019, P101A, or U010E is not set.
- The ignition is on.
- The ignition voltage is greater than 11 V.
- The reductant control module is not initializing.
The DTCs run continuously when the above conditions are met.
P2ADD
- DTC P1015, P1016, P1017, P1018, P1019, P101A, P206C, P206D, or U010E is not set.
- The ignition is on.
- The ignition voltage is greater than 11 V.
- The reductant control module is not initializing.
The DTC runs continuously when the above conditions are met.