Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P24B0
- DTC P142C, P142D, P142E, P142F, P1474, P1475, P1476, P1477, P1478, P16D7, P16D8, P16D9, P24B0, P24B1, P24B3, P24B5, P24B6, P24D0, U02A3 = Not set
- Ignition On
- Ignition Voltage = Greater than 11 V
- Reductant Control Module Relay = ON
- Particulate Matter Sensor = 560 to 800°C (1, 040 to 1, 472°F)
Frequency the DTC runs = Continuously - After the running conditions are met
P24B1, P24B3, P24B5, P24B6, P24D0
- DTC P16D7, P16D8, P16D9, P24D0, U02A3 = Not set
- Ignition On
- Ignition Voltage = Greater than 11 V
- Reductant Control Module Relay = ON
Frequency the DTC runs = Continuously - After the running conditions are met
P24C7
- DTC P24B0, P24B1, P24D0, U02A3 = Not set
- Ambient Air Temperature = Warmer than -20°C (-4°F)
- Barometric Pressure = Greater than 55 kPa (7.9 PSI)
- Ignition On
- Ignition Voltage = Greater than 11 V
- Particulate Matter Sensor Operation = Allowed
- Reductant Control Module Relay = ON
- Time since diagnostic ran last = DPF Regeneration - Greater than 300 s
Frequency the DTC runs = Continuously - After the running conditions are met
P24D1
- DTC P16D7, P16D8, P16D9, P24D0, U02A3 = Not set
- Ignition On
- Ignition Voltage = Greater than 11 V
- Reductant Control Module Relay = ON
- Particulate Matter Sensor Operation = Allowed
- Time since diagnostic ran last = DPF Regeneration - Greater than 150 s
Frequency the DTC runs = Continuously - After the running conditions are met