Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P227BCondition 1
The following parameters are not within 15 kPa (2.2 PSI) of each other :
- BARO Sensor 1
- BARO Sensor 2
- MAP Sensor
Condition 2
BARO Sensor 2 50 to 115 kPa (7.3 to 16.7 PSI)
P227C
BARO Sensor 2 = Less than 1.8 V - For greater than 5 s
P227D
BARO Sensor 2 = Greater than 4.5 V - For greater than 5 s
P227E
BARO Sensor 2 = Signal noisy or erratic - For greater than 5 s