Repair Instructions

WARNING: This page is about a different variant/trim than selected.

Perform the Diagnostic Repair Verification after completing the repair : Diagnostic Repair Verification

Engine Control Module Replacement - K20 Engine Control Module
For control module replacement, programming, and setup refer to : Control Module References

Additional Procedures

NOTE:

The DTC causing the Driver Information Center message/speed limitation to set must run and pass before the message/speed limitation will clear. This may require driving the vehicle.

Ignition - On / Vehicle - In Service Mode
Verify that all scan tool Event Data parameters under the following data list displays No : Exhaust Gas Recirculation System Malfunction Warning Event Data
- If not the specified state
  Operate the vehicle within the Conditions for Running the DTC for the Event Data parameter that displays Yes.
- Go to next step : If the specified state
All OK.