Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P2227Condition 1
The following parameters are not within 46 kPa (6.7 PSI) of each other :
- BARO Sensor 1
- BARO Sensor 2
- MAP Sensor
Condition 2
BARO = Not between 50 and 115 kPa (7 and 17 PSI)
Condition 3
The following parameters are not within 10 kPa (1.5 PSI) of each other :
- BARO Sensor 1
- BARO Sensor 2
- MAP Sensor
The above condition(s) must occur for greater than 1 s.
P2228
BARO = Less than 1.8 V - For greater than 5 s
P2229
BARO = Greater than 4.7 V - For greater than 5 s
P2230
BARO = Signal noisy or erratic - For greater than 5 s