Repair Instructions
WARNING: This page is about a different variant/trim than selected.
Perform the Diagnostic Repair Verification after completing the repair : Diagnostic Repair Verification
- Emission Reduction Fluid Controller Replacement - K115 Reductant Control Module
- Emission Reduction Fluid Supply Pump Module Replacement - A38 Reductant Pump and Sensor Assembly
- For control module replacement, programming, and setup refer to : Control Module References
Additional Procedures
NOTE:
Performing this procedure will clear the Driver Information message for the applicable system.
Perform the scan tool control function : Reductant System Tamper Service Bay Test - Perform only when the following warning message is displayed : Service Emission System/Service Exhaust Fluid System