Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P203B, P203C, P203D is not set.
- If DTC P203B, P203C, P203D is set
Refer to : Circuit/System Testing
- Go to next step : If DTC P203B, P203C, P203D is not set
- If DTC P203B, P203C, P203D is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC is not set
- If the DTC sets
- All OK.