Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) , or Battery Negative Cable Disconnection and Connection (Dual Battery)
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Starter Heat Shield (4) - Remove - Starter Shield Replacement (LV1)
Protective Sleeve (3) - Reposition
- Electrical Connector (4) @ Starter Solenoid - Disconnect
- Battery Positive Cable Nut (2) - Remove
- Battery Positive Cable (1) - Remove
Engine Oil Cooler Pipe (1) - Reposition - Engine Oil Cooler Pipe Replacement (LWN) , or Engine Oil Cooler Pipe Replacement (LV1)
Remove the right side flywheel inspection cover bolt (1).
Starter Mounting Bolt (2) - Remove [2x]
- Remove the starter (1) with the right side flywheel inspection cover.