Removal Procedure
The automatic transaxle range selector cable is made out of two cable sections. After initial connection never separate the two metal couplings from one another. Integrity of the connection of the two metal couplings will be lost if separation of the two metal couplings occurs. When servicing the transaxle remove the cable at the automatic transaxle range selector lever and at the automatic transaxle range selector cable bracket. If either section of the cable needs to be replaced, replace both of the cable sections. Loss of connection integrity of the two metal couplings can cause loss of transaxle shift control which could result in personal injury.
- Apply the parking brake.
- Position the steering column shift lever to park.
- Remove the knee bolster bracket. Instrument Panel Knee Bolster Bracket Replacement (Left Side) , or Instrument Panel Knee Bolster Bracket Replacement (Right Side)
Remove the clip (3) securing the shift cable to the steering column bracket.
- Remove the shift cable (1) from the steering column shift control (2).
- Remove the left side body hinge pillar trim panel. Body Hinge Pillar Trim Panel Replacement
- Pull back the carpet and insulation to gain access to the shift cable pass-through grommet.
Remove the rubber grommet (2) from the floor panel.
- Disconnect the retainer (1).
- Raise the vehicle. Lifting and Jacking the Vehicle
- Disconnect the range selector lever cable retainer located on the left side underbody near the cable adjuster.
Remove the shift cable (2) from the shift lever (3).
- Remove the locking clip (1) from the cable at the bracket.
- Lower the vehicle.
- Remove the shift cable from the vehicle.