LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Diagnostic Information And Procedures (3 Of 3)) >> Diagnostic Information and Procedures >> DTC P24A0 or P24A1 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition On.
  2. Verify DTC P00C7, P00E9, P00EA, P00EB, P00EC, P0101, P0102, P0103, P0106, P0107, P0108, P0116, P0117, P0118, P0119, P0128, P0201, P0202, P0203, P0204, P020A, P020B, P020C, P020D, P0216, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P02EE, P02EF, P02F0, P02F1, P0405, P0406, P049D, P0502, P0503, P062B, P062D, P0722, P0723, P111E, P113E, P1197, P1248, P1249, P124A, P124B, P126A, P2147, P2148, P2150, P2151, P2470, P2471, or P2472 is not set.
    • Go to next step: If a DTC is not set 
  3. Verify that the resistance of the B131 Exhaust Gas Temperature Sensor 3 and 4 is within the range specified in Temperature Versus Resistance - Exhaust Gas Temperature Sensor
    • If not within the specified range 

      Replace the appropriate B131 Exhaust Gas Temperature Sensor

    • Go to next step: If within the specified range 
  4. Verify the following conditions do not exist:
    • If a condition is found 

      Repair as necessary.

    • Go to next step: If no condition is found 
  5. Perform the Diesel Particulate Filter Service Regeneration
  6. Verify the regeneration completed.
    • If the regeneration did not complete 

      Replace the exhaust particulate filter.

    • Go to next step: If the regeneration completed 
  7. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  8. Verify the DTC does not set.
    • If a DTC sets 

      Replace the exhaust particulate filter.

    • Go to next step: If the DTC does not set 
  9. All OK.