LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Diagnostic Information And Procedures (1 Of 3)) >> Diagnostic Information and Procedures >> DTC P040B-P040E or P041B-P041E >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter: EGR Cooler Temperature Sensor 1, 2 = -39 to 999°C (-38 to 1830°F) and changes
    • If not between -39 and 999°C (-38 and 1830°F) or does not change 

      Refer to: Circuit/System Testing

    • Go to next step: If between -39 and 999°C (-38 and 1830°F) and changes 
  3. Verify the scan tool parameter: EGR Cooler Temperature Sensor 1, 2 = The value should not spike or drop out.

    Perform the action while monitoring the parameter:

    • Wiggle the harness and connector: B130 Exhaust Gas Recirculation Temperature Sensor
    • Wiggle the harness and connector: X3 @ K20 Engine Control Module
    • If the value spikes or drops out 

      Repair as necessary - Wiring / Terminal(s) / Electrical Connector(s)

    • Go to next step: If the value does not spike or drop out 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals