Circuit/System Verification
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P1248 - P124F is not set and no other DTCs are set.
- If DTC P1248 - P124B is not set and other DTCs are set
Refer to: Circuit/System Testing - Test 1
- If DTC P1248 - P124B is set and other DTCs are set
Refer to: Circuit/System Testing - Test 2
- If DTC P1248 - P124B is set and no other DTCs are set
Refer to: Circuit/System Testing - Test 3
- Go to next step: If no DTC is set
- If DTC P1248 - P124B is not set and other DTCs are set
- Engine - Running
- Verify the scan tool parameter: Cylinder 1 - 4 Current Misfire Counter = Does not Increment
Perform the action while monitoring the parameter:
Wiggle the harness and connector: K20 Engine Control Module
- If the parameter value increments
Repair as necessary - Wiring / Terminal(s) / Electrical Connector(s)
- Go to next step: If the parameter value does not increment
- If the parameter value increments
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Repeat step 2
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.
NOTE:
This step only applies to the following component DTCs: Q17 Fuel Injector