Removal Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the control valve body from the transmission. Refer to Control Valve Body Replacement .
Disconnect the electrical connector (1).
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Remove the input and output speed sensor wiring harness bolts and Discard (1).
- Disconnect the input and output speed sensor wiring harness retainers (4).
- Remove the automatic transmission input and output speed sensor wiring harness (3) from the transmission.