Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Position the floor rail (2) to the vehicle.
- Install the rear floor mat/carpet.
- Raise the vehicle and support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle .
Install the rear seat track reinforcements to the seat track studs (12 and 15 Passenger).
Inspect the nuts (3) in order to ensure that the sealer is intact.
- If the sealer is not intact, apply a medium bodied sealer to the nuts before installing.
- CAUTION:
Refer to Fastener Caution .
Install the nuts to retain the floor rail to the vehicle and tighten to 43 N.m (32 lb ft).
- Install the heat shields to the vehicle.
- Install the spare tire to the vehicle.
- Remove the safety stands.
- Lower the vehicle.
- Install the rear passenger seats to the vehicle. Refer to Rear Bench Seat Removal and Installation (With Bench Seat) , or Rear Bench Seat Removal and Installation (With Split Bench) .