Installation Procedure
- NOTE:
If the valve rocker arm cover grommets are cracked or damaged, replace the valve rocker arm cover bolts. The grommet is serviced with the rocker arm cover bolt.
Valve Rocker Arm Cover Gasket (2) - Install a NEW gasket.
- Valve Rocker Arm Cover (1) - Install
- CAUTION:
Refer to Fastener Caution .
Valve Rocker Arm Cover Bolt (1) - Install and tighten [4x] 12 N.m (106 lb in)
Ignition Coil Bracket (2) - Install
- Ignition Coil Bracket Bolt (1) - Install and tighten [5x] 12 N.m (106 lb in)
Electrical Connector (1) @ Ignition Coil Bracket - Connect
Spark Plug Wire (1) @ Ignition Coil - Install [4x] - Spark Plug Wire Replacement
Positive Crankcase Ventilation Tube (1) @ Valve Rocker Arm Cover - Install - Positive Crankcase Ventilation Hose/Pipe/Tube Replacement (Air Cleaner Resonator Outlet Duct to Valve Rocker Arm Cover) , or Positive Crankcase Ventilation Hose/Pipe/Tube Replacement (Intake Manifold to Valve Rocker Arm cover)
Oil Level Indicator Tube-Upper (1) - Install - Oil Level Indicator Tube Replacement (Upper)
Oil Filler Tube (1) - Install - Oil Filler Tube Replacement
Coolant Recovery Reservoir (1) - Install - Coolant Recovery Reservoir Replacement (L96, LC8)