Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Align the splined surfaces of the crankshaft sprocket and the oil pump drive gear and install the oil pump (413).
- Install the oil pump onto the crankshaft sprocket until the pump housing contacts the face of the engine block.CAUTION:
Refer to Fastener Caution .
- Install the oil pump bolts (411) and tighten to 25 N.m (18 lb ft).
Install the crankshaft oil deflector and nuts until snug.
Lubricate a NEW oil pump screen O- Ring seal (406) with clean engine oil.
- Install the NEW O- Ring seal onto the oil pump screen.
- Align the oil pump screen mounting brackets with the correct crankshaft bearing cap studs.
- Install the oil pump screen (407).
- Install the oil pump screen bolt (405) and nuts (404).
- Tighten the oil pump screen bolt to 12 N.m (106 lb in).
- Tighten the crankshaft oil deflector/oil pump screen nuts to 25 N.m (18 lb ft).
- Install the engine front cover. Engine Front Cover Replacement
NOTE:
Push the oil pump screen tube completely into the oil pump prior to tightening the bolt. Do not allow the bolt to pull the tube into the pump.