LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Mechanical - 6.0L (L96 LC8)) >> Diagnostic Information and Procedures >> Camshaft Position Actuator and Solenoid Valve Diagnosis and Testing

Camshaft Position Actuator and Solenoid Valve Diagnosis and Testing

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the engine oil level. Fill, as required.
  2. Using the scan tool, inspect for diagnostic codes within the engine control module (ECM). Refer to Diagnostic System Check - Vehicle . Repair, as required.
  3. Verify proper engine oil pressure and operation of the active fuel management oil pressure relief valve. Refer to Oil Pressure Diagnosis and Testing .
  4. Inspect the CMP actuator solenoid valve for proper operation. Refer to Camshaft Position Actuator Solenoid Valve Inspection (Off-Vehicle) , or Camshaft Position Actuator Solenoid Valve Inspection (On-Vehicle) .
    • If valve inspection confirms proper movement of the spool, replace the CMP actuator and CMP valve.
    • If valve inspection confirms improper movement of the spool, replace only the CMP valve.
  5. Verify proper operation of the CMP actuator control system. Refer to Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals