Fastener Specifications
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Propeller Shaft Center Support Bearing Retainer |
| Propeller Shaft Slip Yoke Boot |
| Propeller Shaft Slip Yoke Boot Clamp |
| Propeller Shaft Universal Joint |
| Propeller Shaft Universal Joint Spider Bearing Retaining Ring |
| Rear Propeller Shaft Retainer |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Rear Propeller Shaft Bolt | 25 N.m (18 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Propeller Shaft Bearing Bolt | 40 N.m (30 lb ft) |
| Front Propeller Shaft Bearing Nut | 40 N.m (30 lb ft) |
| Propeller Shaft Hanger Bolt | 52 N.m (38 lb ft) |