Removal Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refer to Brake Dust Warning .
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
Front Brake Rotor(1) - Remove - Front Brake Rotor Replacement (JH6) , or Front Brake Rotor Replacement (JH9)
Electrical Connector(1) - Disconnect
Clip(1) - Release
Clip(1) - Release
Clip(1) - Release
Wheel Speed Sensor Bolt(1) - Remove
- CAUTION:
Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device. Prying will cause the sensor body to break off in the bore.
Wheel Speed Sensor(1) - Remove