LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Disc Brakes) >> Repair Instructions >> Rear Brake Caliper Replacement (JH6) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
  3. GM4830097Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Fitting Bolt(1) - Remove

  4. GM4830098Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT reuse the brake hose fitting gaskets.

    Brake Hose Fitting Gasket (1)@Brake Hose Fitting (2) - Remove and DISCARD[2x]

  5. Cap the brake hose fitting to prevent brake fluid loss and contamination.
  6. GM4830099Courtesy of GENERAL MOTORS COMPANY

    Brake Caliper Guide Pin Bolt- Lower(1) - Remove

  7. GM4830100Courtesy of GENERAL MOTORS COMPANY

    Brake Caliper Guide Pin Bolt- Upper(1) - Remove

  8. GM4830101Courtesy of GENERAL MOTORS COMPANY

    Brake Caliper(1) - Remove