Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
Brake Caliper(1) - Install
- CAUTION:
Brake Caliper Guide Pin Bolt- Upper(1) - Install and tighten - Rear Brake Caliper Hardware Replacement (JH6) , or Rear Brake Caliper Hardware Replacement (JH9)
Brake Caliper Guide Pin Bolt- Lower(1) - Install and tighten - Rear Brake Caliper Hardware Replacement (JH6) , or Rear Brake Caliper Hardware Replacement (JH9)
- NOTE:
Install NEW brake hose fitting gaskets.
Brake Hose Fitting Gasket(1)@Brake Hose Fitting (2) - Install NEW[2x]
Brake Hose Fitting Bolt(1) - Install and tighten - Rear Brake Hose Replacement
- Bleed the brake system. Hydraulic Brake System Bleeding (Pressure) , or Hydraulic Brake System Bleeding (Manual)
- Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Adhesives, Fluids, Lubricants, and Sealers
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
- Remove the support and lower the vehicle.