Installation Procedure
- Apply a light coat of high temperature silicone brake lubricant to the brake caliper guide pin surfaces. Adhesives, Fluids, Lubricants, and Sealers
- Apply lubricant to the brake caliper guide pin shafts.
- Apply lubricant to the brake caliper guide pin seats.
- Apply lubricant to the brake caliper guide pin threads.
- CAUTION:
Refer to Fastener Caution .
NOTE:The lower Rear Brake Caliper Guide Pin is equipped with a bushing.
Rear Brake Caliper Guide Pin- Lower(2) - Install and tighten61 N.m (45 lb ft)
- Rear Brake Caliper Guide Pin- Upper(1) - Install and tighten61 N.m (45 lb ft)
- Apply a light coat of high temperature silicone brake lubricant to the brake caliper guide pins and guide pin bores.
Rear Brake Caliper Guide Pin Seal(2) - Install - Rear Disc Brake Mounting and Hardware Inspection (With Single Rear Wheel) , or Rear Disc Brake Mounting and Hardware Inspection (With Dual Rear Wheel)
Ensure the rear brake caliper guide pin seals are fully seated in the groove of the rear brake caliper housing.
- Rear Brake Caliper Guide Pin Boot(1) - Install - Rear Disc Brake Mounting and Hardware Inspection (With Single Rear Wheel) , or Rear Disc Brake Mounting and Hardware Inspection (With Dual Rear Wheel)
Ensure the rear brake caliper guide pin boots are fully seated in the groove of the rear brake caliper housing.
Rear Brake Caliper Bracket(1)@Rear Brake Caliper - Install
Rear Disc Brake Pad Retainer Spring(1) - Install[4x]
Rear Disc Brake Outer Pad(2) - Install
- Rear Disc Brake Inner Pad(1) - Install
Install the rear brake caliper and bracket assembly (1). Rear Brake Caliper Replacement (JH6) , or Rear Brake Caliper Replacement (JH9)