Installation Procedure
WARNING: This page is about a different car, the 2019 GMC Savana 3500, 2019 GMC Savana 2500, 2019 Chevrolet Express 3500, and 2019 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
- Thoroughly clean the brake pad hardware mating surfaces of the caliper bracket of any debris and corrosion.
Front Disc Brake Pad Retaining Spring(1) - Install NEW[2x]
Front Disc Brake Pad(1) - Install[2x]
Front Brake Caliper(1) - Install - Front Brake Caliper Replacement (JH6) , or Front Brake Caliper Replacement (JH9)
- NOTE:
Do NOT use air tools to remove or install the guide pin bolts. Use hand tools ONLY.
Front Brake Caliper Guide Pin Bolt(1) - Install and tighten[2x] - Front Brake Caliper Guide Pin Replacement (JH6) , or Front Brake Caliper Guide Pin Replacement (JH9)
- Install the front tire and wheel assemblies. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
- Lower the vehicle.
- With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 7 - 8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
- Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Adhesives, Fluids, Lubricants, and Sealers
- Burnish the brake pads and rotors. Brake Pad and Rotor Burnishing